Newport-brass 999L East Linear User Manual Page 3

  • Download
  • Add to my manuals
  • Print
  • Page
    / 3
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 2
Installing Drain Components
Remove drain PLUG (A) from FLANGE (B).
Place FLANGE (B) and white WASHER (C) through sink drain open-
ing. (Clear silicone may be used in place of white washer.)
From bottom side of sink, place cone shaped rubber WASHER (D)
onto FLANGE (B) and slide up against sink bottom.
Note: Cone portion of WASHER (D) to face upward.
Slide on clear flat WASHER (E) and secure with flange NUT (F).
Place clear WASHER (G) into drain BODY (H) and tighten to
FLANGE (B).
Apply thread sealant to TAILPIECE (J) and attach to drain BODY (H).
Attach TAILPIECE (J) to p-trap drain (not included).
Place drain PLUG (A) into FLANGE (B).
Insert pop-up ROD (L) through rod opening and secure to STRAP
(M), approximately 1" from end of ROD (L), with SCREW (N).
Insert ball ROD (P) into the drain's rod opening, secure with ball rod
NUT (Q).
Adjust the rise of the plunger and CLIP (R) into place.
Adjust ball ROD (P) and pop-up ROD (L) so drain will open and
close properly. See Figure 6.
Connect TAILPIECE (J) to waste p-trap (not included).
Finish Trim
Place handle into valve STEM and secure in place. Any adjustments for
rotational alignment must be made to the valve body, not to the cartridge. (Cartridge Bonnet factory torque
is 14-16 ft-lbs.)
Attach hot/cold water supply to appropriate 1/2” NPSM valve BODY (4), utilizing one of the three following
types of risers. Supply risers not included. See Figure 2.
a. 1/2” IPS flexible riser: discard rubber nosecone WASHER (5), friction WASHER (4) and coupling NUT (6).
b. 3/8” or 1/2” OD bullnose riser: utilize friction WASHER (4) and coupling NUT (6).
c. 1/2” copper riser: utilize rubber nosecone WASHER (5), friction WASHER (4) and coupling NUT (6).
Remove AERATOR (27) from douche spray BODY (23). Turn on water supply.
Rotate diverter handle and flush lines until water is clear.
Reattach AERATOR (27) and check for leaks.
Drain basin and check drain seals.
Top View of Bidet Showing Locations of:
1. Diverter Valve
2. Hot & Cold Valves
3. Pop-Up Knob/Rod
4. Pop-Up Drain
5. Douche Spray
Figure 6
Figure 7
2
2
3
4
5
1
A
B
C
D
E
F
G
H
J
L
M
N
R
Q
P
(949)417-5207
NWP-2-235 Santa Ana, Ca. 92705 10/10/2011
www.brasstech.com
Page view 2
1 2 3

Comments to this Manuals

No comments